Thumbnail Image

Kerala Agricultural University, Thrissur

The history of agricultural education in Kerala can be traced back to the year 1896 when a scheme was evolved in the erstwhile Travancore State to train a few young men in scientific agriculture at the Demonstration Farm, Karamana, Thiruvananthapuram, presently, the Cropping Systems Research Centre under Kerala Agricultural University. Agriculture was introduced as an optional subject in the middle school classes in the State in 1922 when an Agricultural Middle School was started at Aluva, Ernakulam District. The popularity and usefulness of this school led to the starting of similar institutions at Kottarakkara and Konni in 1928 and 1931 respectively. Agriculture was later introduced as an optional subject for Intermediate Course in 1953. In 1955, the erstwhile Government of Travancore-Cochin started the Agricultural College and Research Institute at Vellayani, Thiruvananthapuram and the College of Veterinary and Animal Sciences at Mannuthy, Thrissur for imparting higher education in agricultural and veterinary sciences, respectively. These institutions were brought under the direct administrative control of the Department of Agriculture and the Department of Animal Husbandry, respectively. With the formation of Kerala State in 1956, these two colleges were affiliated to the University of Kerala. The post-graduate programmes leading to M.Sc. (Ag), M.V.Sc. and Ph.D. degrees were started in 1961, 1962 and 1965 respectively. On the recommendation of the Second National Education Commission (1964-66) headed by Dr. D.S. Kothari, the then Chairman of the University Grants Commission, one Agricultural University in each State was established. The State Agricultural Universities (SAUs) were established in India as an integral part of the National Agricultural Research System to give the much needed impetus to Agriculture Education and Research in the Country. As a result the Kerala Agricultural University (KAU) was established on 24th February 1971 by virtue of the Act 33 of 1971 and started functioning on 1st February 1972. The Kerala Agricultural University is the 15th in the series of the SAUs. In accordance with the provisions of KAU Act of 1971, the Agricultural College and Research Institute at Vellayani, and the College of Veterinary and Animal Sciences, Mannuthy, were brought under the Kerala Agricultural University. In addition, twenty one agricultural and animal husbandry research stations were also transferred to the KAU for taking up research and extension programmes on various crops, animals, birds, etc. During 2011, Kerala Agricultural University was trifurcated into Kerala Veterinary and Animal Sciences University (KVASU), Kerala University of Fisheries and Ocean Studies (KUFOS) and Kerala Agricultural University (KAU). Now the University has seven colleges (four Agriculture, one Agricultural Engineering, one Forestry, one Co-operation Banking & Management), six RARSs, seven KVKs, 15 Research Stations and 16 Research and Extension Units under the faculties of Agriculture, Agricultural Engineering and Forestry. In addition, one Academy on Climate Change Adaptation and one Institute of Agricultural Technology offering M.Sc. (Integrated) Climate Change Adaptation and Diploma in Agricultural Sciences respectively are also functioning in Kerala Agricultural University.

Browse

19841
Reset filters
Subject: Agricultural Engineering × End date: 1984 × Start date: 1984 × Type: Thesis × Thesis Type: M.Sc ×
Reset filters

Search Results

Now showing 1 - 1 of 1
  • Thumbnail Image
    ThesisItemOpen Access
    Design and development of a propeller pump
    (Department of Agricultural Engineering, College of Horticulture, Vellanikkara, 1984) Sasi, K; KAU; Remadevi, A N
    “Petti and Para” a crude form of Axial flow pump is used in Kerala for dewatering agricultural fields. It is being fabricated by local blacksmiths and there is no scientific design for the pump. For low head high discharge conditions Petti and Para is very effective, but less efficient because of faulty construction. The broad objective of the project was to develop an axial flow pump with improved efficiency which could be economically used for dewatering and for lift irrigation purposes under low head conditions. In this investigation, a good amount of attention was given to the fluid dynamics inside the axial flow pump and theoretically studied the combined affect of various parameters involved in the design of an axial flow pump. Then the parameters were compared with the approximate values given by the various researchers in the field. The requirement of the pump to be designed, at field conditions, were studied thoroughly and an one dimensional design was done. After designing and fixing the dimensions, the pump was fabricated in the Kerala Agricultural University Research Workshop at Mannuthy. Because of the lack of facilities in the Research Workshop, it was tested in the hydraulics laboratory at the Government Engineering College, Trichur. The power unit used was a 15 HP electric motor. The accessories used to measure discharge and head were a rectangular notch with Hookgauge and water manometer respectively. Testing was done with two levels of water above the impeller, one 20 cm above the impeller and the other 10 cm above the impeller. For the above two conditions, at designed head (1.5m) the maximum efficiencies obtained were 33 per cent and 29.5 per cent at discharge 121 lit/sec. and 114 lit/sec. respectively. The maximum working capacity was 165.19 lit/sec. against a head of 1 m with an efficiency of 31.95 per cent (20 cm above the impeller) In the three bladed pump, the blades were fixed to the hub by welding it to the suitably shaped (curved) M.S flats and then bolting the curved M.S. flats to the hub. The blades were twisted from 160 to 240 in a uniform variation by simple blacksmithy. The efficiency of the pump can be increased by using perfectly curved blades, which reduces eddies and skin friction. Comparing with the existing Petti and Para made by local blacksmiths, it is found that the pump is cheap as well as efficient.